Vax V-021 Instruction Manual - 7. Troubleshooting
4
When finished cleaning remove the dirty water
tank and rinse with warm water and allow it to
dry before storage. Also remove filter (as
shown) rinse with warm water and allow it to dry
thoroughly before storing.
IMPORTANT: Do not use any chemicals when
cleaning.
NOTE: Do not store cleaner with solution in clean
water tank or dirty water in dirty water tank.
Mineral deposits and mildew can form with will
affect the performance of the carpet washer.
7. Troubleshooting
WARNING: To reduce risk of personal injury,
unplug carpet washer before servicing.
Problem: The cleaner won't run
Cause:
Not properly plugged into electrical outlet.
Solution: Plug in firmly.
Cause:
No electricity in electrical outlet.
Solution: Check fuse or breaker.
Cause:
On/off switch not turned on.
Solution: Push on/off switch to ‘on’.
Cause:
Blown fuse/tripped breaker.
Solution: Reset circuit breaker or replace fuse.
8. UK Service & Help
Vax Care 0870 6061248
Monday-Friday. 9.00am to 5.00pm.
An answerphone will be available out of these hours.
Any queries or concerns about using your Vax, call the
Vax Careline. Calls are charged at the UK national rate.
Please make a note of the serial number and model
number of your carpet cleaner before calling. There are
over 400 approved Vax Service Agents in the UK. For
the nearest Vax Service Agent, please call the Vax
Careline or visit www.vax.co.uk
9. Technical Specification
Voltage:
220 ~ 240V 50Hz
Motor Power:
550W
Clean water tank volume:
2.6 litres
Dirty water tank volume:
2.4 litres
Cord length:
6.1m
Weight:
5.7kg
7
Fig.6/4
Fig.6/5
Fig.6/6
V-021 User Guide.qxd 5/6/06 4:14 pm Page 8