Vax V-028 Instruction Manual - page 6
Clean water
tank handle
Clean water
tank latch
Fig.5/1
Fig.5/2
Fig.5/3
5. Pre-treating your Carpet
Grasp the clean water tank under the handle
while pressing the clean water tank latch. Tilt
the clean water tank away from the carpet
washer and remove.
Unscrew the measuring cap from the back of
the clean water tank.
Fill the measuring cap with the VAX Carpet
Cleaning fluid.
Pour into the clean water tank.
Fill the remainder of the clean water tank with
warm (max 40oC) tap water. Replace the
cap.
Place the bottom of the clean water tank into
the carpet washer and rotate top into position
until the clean water tank latch snaps into
place.
Attach the pre-treatment wand to the water
supply port and press firmly until it locks into
place.
Fig.5/4
Fig.5/6
Fig.5/5
BACK
VIEW
6
7
6. How to Operate
Clean water
tank handle
Clean water
tank latch
Unscrew measuring cap from back side of
clean water tank.
Fig.5/7
Fig.5/8
Fig.5/9
Fig.6/1
Fig.6/2
Fig.6/3
To pre-treat your carpet, step on the power
on/off pedal to turn the cleaner on.
Using the wand and the trigger, apply the
pre-treatment solution to your carpets.
Turning the spray nozzle clockwise or anti-
clockwise will alter the spray pattern.
Releasing the trigger will stop the solution
flow.
The treated areas should be left for 10 to 15
minutes.
For heavy stains, mild agitation may be used.
NOTE: Do not over wet carpets.
NOTE: Once your carpets have been pre-
treated, rinse the clean water tank and clean
your carpets with Vax Carpet Cleaner as
directed.
Grasp clean water tank under handle while
pressing clean water tank latch. Tilt clean
water tank away from cleaner and remove.
Fill measuring cap with solution. Pour into
clean water tank.
NOTE: Use only Vax Carpet Cleaner
solution.
Using other cleaning solutions may cause
excess foaming. Excessive foam will cause
the float to shut off the carpet washer prema-
turely. Using other solutions can void the
warranty.