Vax VCC-05 User Manual - page 7
Vax Service line:
AU: 1300 361 505
NZ: 0800 800 900
vax.com.au
6
Maintenance
(Keep your Vax as good as new)
Dirt container removal and replacement
IMPORTANT: Always unplug the vacuum cleaner from the electrical outlet before removing the dust bag.
IMPORTANT: DO NOT use the vacuum cleaner without ALL of the filters in place.
Turn off the vacuum cleaner and unplug it from the electrical outlet.
Dust Bag Replacement
Turn off the vacuum cleaner and unplug it from the
mains. Remove the hose. Unclip the retainer clip on the
top of the unit and lift up to gain access to the dust
bag compartment.
Lift out the full dust bag
Dispose the full dust bag
and insert a new dust bag
into the vacuum cleaner.
Align the front of the dust
bag with the air entrance.
NOTE: The seal ring
around the dust bag
opening should cover the
air entrance connector
inside the housing.
Pre-motor filter (Model VCC-05 only)
Unclip the retainer clip on
the top of the vacuum
cleaner and lift up to gain
access to the dirt container
department.
The pre-motor filter is
found in the centre of the
dirt container. Rotate the
filter retaining disc
anti-clockwise to gain
access to the filter.
The pre-motor filter can be
lifted out.
NOTE: Vax recommends
replacing the pre-motor
filter every 3-6 months
depending on the level of
use or when it becomes
discoloured.
Replace with a new filter
inside and turn the retaining
disc clockwise to secure.