Vax VCC-05 User Manual - page 9
Vax Service line:
AU: 1300 361 505
NZ: 0800 800 900
vax.com.au
8
FAQ’s
Problem
Cause
Solution
Cleaner won’t run
Not properly plugged into electrical outlet.
Plug unit in firmly.
Vacuum cleaner not turned on.
Press on/off button.
No electricity in the electrical outlet.
Check fuse or breaker.
Blown fuse/tripped breaker.
Reset circuit breaker or replace fuse.
Motor thermostat has tripped.
Switch off and unplug the vacuum cleaner.
Leave for one (1) hour. See page 3.
Cleaner won’t pick up/loss
of suction
Dust bag not installed correctly.
Review dust bag removal and replacement.
Dust bag full or blocked.
Replace dust bag. Empty/clean/replace
cloth bag
Clogged filter.
Remove/replace with new filter VCC-05.
Remove wash/replace HEPA filter VCC-07.
Blockage in hose.
Disconnect hose, remove the obstruction
then re-fit.
Accessories won’t pick up
Accessories are not attached correctly.
Refer to page 4 for fitting information.
Dust escaping from the
vacuum cleaner
Dust bag full.
Dispose of paper dust bag, replace with a new
one or empty/clean/replace cloth bag.
Dust bag not installed correctly.
Review dust bag removal and replacement.
Hose is not installed correctly.
Review hose installation.
Filter not installed completely.
Review filter removal and replacement.
WARNING: To reduce the risk of personal injury, unplug the vacuum cleaner before performing
maintenance/troubleshooting checks.