Vdwall LVP603S User Manual - page 14
LVP603S User’s Manual
---------------------------------------------------------------------------------------------------
LED VIDEO PROCESSOR
14
brightness, and 64 represents the highest brightness.
Press “
←
” or “
→
” to increase or decrease the values of brightness.
Press “
Enter
” to save the settings.
To ensure full gray level of output image, normally the output
brightness is set as
64
!
Item 8
: “
Color”
For V1, V2, DP and HDMI video input source,
LVP603S
can set
color saturation for them ranging from 22 to 38. The lower this value is,
the weaker the color looks; the higher this value is, the stronger the
color looks. Press “
←
” or “
→
” to increase or decrease the values of
color saturation. Press “
Enter
” to save the settings.
Normally the value of color saturation is set as
30
!
Item 20: “
Definition”
LVP603S
provides “sharp” or “normal” as options of definition. In
sharp mode, the picture edge looks clearly, and image has higher
definition; while in “normal” mode, the picture looks milder. Normally
the value of
Definition
saturation is set as “normal”!
5. PIP/POP Output Image Setup
Items 9~12: “
PIP image output setup
”
LVP603S PIP image window is located in LED screen. As in PIP
mode the PIP image is to be zoomed-in/out after being added to
background, it means that 4 values listed in items 9~12 in the table
below don’t represent their pixels in LED, but represent the width and
height value of output resolution “
Out_Format
” in the 6
th
option of
setting menu. For details see figure below (provided “
Out_Format
”
adopts
1920
×
1080
mode).
Note: the minimum values of
PIP_H_Width
and
PIP_V_Heigh
are
both 128.
9
PIP_ H_Start
PIP horizontal start
10
PIP_H_Width PIP
width
11
PIP_V_Start
PIP vertical start
12
PIP_V_Heigh PIP
height