Vdwall LVP615 series Quick User Manual - page 6
地址:深圳市南山区科技园北区同方信息港
C
栋
5B
网址:
www.videowall.cn
电话:
+86-755-2675 0210
传真:
+86-755-2675 0185
LVP615
系列快速使用指南
“ copy” “ extend” or “ dual display “ .
2) Set the monitor resolution as the same of LVP615 output resolution. The LVP615 LCD will
display current computer resolution.
Step 8
:
part / full display
(
Bypass
)
1) Press DVI key to select DVI input signal. Make sure DVI input resolution is bigger than the
LVP615 output width and height.
2) Press
Bypass
key and indicator on, LED screen is under part pixel to pixel display situation.
Picture is not compressed.
3) Then press
Bypass
key and indicator off, LED screen is under full display situation. Picture
is compressed to display whole on the LED screen.
Step 9
:
turn on PIP / PBP
1)
In single picture display state, press signal key to select background signal.
2)
Press
ON/OFF
key, LCD will show
:
PIP=
?
3)
Select signal key to select PIP/PBP signal to enter dual pictures display.
4)
LVP615 can presave 3 different kinds of PIP/PBP mode, Press mode key“
M1
~
M3
” to select.
5)
Under PIP / PBP on state,Press
ON/OFF
key to turn off PIP/PBP function. LED screen will
show single picture.
Step 10
:
setup PIP / PBP parameters
1) After turn on PIP/PBP, press
Setup
,
then press
OK
,
LVP615 enter PIP/PBP setup menu.