Vea T100 User Manual - page 10
7
7
After all the connections have been made properly, switch on your
TV. Make sure the receiver is connected to the mains and press
Power to switch the receiver on. If you are using the receiver for
the first time, a First Time Installation menu will be displayed to
guide you through the initial setup. Use the remote controller to
finish the setup.
1. At the First time installation menu, select YES and press OK
on the remote controller to proceed.
2. Enter your regional settings, include your Region, OSD
Language, Time Zone and Antenna Power. Then select
NEXT to proceed.
Note: Make sure to select the region you are located since the receiver
will scan the channels based on the bandwidth of the region you selected.
If your region is not on the list, you are recommended to conduct a manual
search. Refer to
Manual Search
on page 16 for details.
First Time Installation
First Time Installation
Do you want to start first time
Installation Wizard?
YES
NO
England
English
GMT + 00:00
OFF
First Time Installation (1)
BACK
NEXT
Region
Language
Time Zone
Antenna Power