Vector GL2000 User Manual - page 16
User Manual GL2000/GL2010 – Data Logger
GL2000 – Data Logger
© Vector Informatik GmbH
Version 2.4
- 14 -
GL2000 V1.0:
Remove SD card
with event buttons
The
GL2000
V1.0 has no shutdown button on the top cover. Instead you can use the
two buttons on the delivered switch box E2T2L to interrupt an active logging in order
to remove or exchange the SD card.
Therefore the logger must contain the firmware V1.40 or higher (available from
Vector
Logger Configurator
2.6 SP3).
Make the following step to deactivate the SD card:
>
Press the two buttons on the switch box E2T2L simultaneously for five seconds.
After each second a signal tone is heard.
Afterwards the
GL2000
V1.0 is shut down and LED1 to LED4 are off. The USB LED
lights up for 15 seconds. During this time the SD/SDHC card is disconnected from the
system and can be removed.
Do not pull the SD card forcefully from the card holder, because this may damage the
mechanics!
After 15 seconds elapse, the logger changes to sleep mode. When a wake event
such as bus activity occurs, the logger wakes up again and continues logging.
GL2010: SD card
The SD card is already contained in the housing of the
GL2010
and cannot be
removed or replaced.
Note:
Please note that the housing of the
GL2010
must not be opened under any
circumstances, since otherwise the IP65 protection class of the data logger is no
longer guaranteed. The SD/SDHC card may only be replaced by Vector Informatik
GmbH. For more information, please contact the Vector Support.
Data transfer
The logged data can be downloaded with a configuration program from the SD/SDHC
card in the
GL2000
/
GL2010
or in a card reader. Alternatively logging files can be
copied to the PC via the
Windows Explorer
. On the PC the logging files can be
converted.
2.2.3 Serial Number
Serial number
The serial number is stored in the logger and is copied to the SD card after download
of the configuration and start in logging mode.
The configuration program reads out the serial number of the logger in the
configuration mode. The serial number is displayed correctly, if an SD card is inserted
and the logger was at least one time in the logging mode with this SD card. If this SD
card is inserted in another logger and the logger is not started in logging mode
afterwards, the serial number of the first logger will be displayed in the configuration
program.