Vec049 front 4140 s.W. 28th way • ft. Lauderdale, fl 33312 tel 954.584.4446 • fax 954.584.5556 toll-free: (866) 584-5504 owner’s manual this manual contains important information regarding safety, operation, maintenance and storage of this product. To avoid possible injury or property damage, please...
Important safety information to ensure reliable service, your power inverter must be installed and used properly. Please read the installation and operating instructions thoroughly prior to installation and use. Pay particular attention to the warning and caution statements in this manual. The cauti...
The customer is responsible for the shipping charges on all returned items. During the warranty period, vector manufacturing, ltd. Will be responsible for the return shipping charges. Limitations: this warranty does not cover accessories, bulbs, fuses and batteries, defects resulting from normal wea...
1.0 introduction your new vector maxx sst 1000 inverter is one in a series of the most advanced dc to ac inverters available. With proper care and appro- priate usage, it will give you years of dependable service in your car, truck, rv or boat. The maxx sst 1000 supplies 1000 watts of continuous pow...
8.2 troubleshooting guide trouble/ indication possible cause suggested remedy no ac output – dc input below 10 volts recharge or replace red led lit battery no ac output – excessive appliance reduce load-wait for red led lit load-thermal shutdown inverter to cool. Turn off low battery alarm bad conn...
1.2 maxx sst 1000 safety features built-in safety features include: • automatic overload and over-temperature shutdown activated if ac output exceeds 1000 watts. • automatic ac short-circuit shutdown and automatic reset • automatic low voltage audible alarm and reset (sounds at 10.6 volts input) • a...
17. Check to ensure that all electrical connections are tight. 18. Ensure that the inverter’s on/off switch is off. 19. Insert the fuse into the fuse holder. There may be some sparking. 20. Turn on the inverter and apply a test load to the ac outlets. 21. Check all connections and tighten any loose ...
2.0 inverter applications aside from issues of supplying power to higher wattage appliances, inverters must be supplied with a constant source of high current12 volt dc from a bank of batteries. At full 1000 watt load, the dc input require- ments are up to 100 amperes at 12 volts dc. Read the follow...
The inverter can be operated in any position, however, if it is to be mounted on a wall, mount it horizontally so that indicators, switches, outlets and terminal blocks located on the front panel are visible and accessible. If inverter is to be installed in a moving vehicle, vector strongly recommen...
The 110 vac output of the inverter is in the form of a modified sine wave (msw) as shown in figure 5. This type of waveform has the same energy characteristics as the sine wave of commercial electrical power. The modi- fied sine wave is superior to the 100% square wave output (not shown) produced by...
Cautions: this device supplies 110 vac electrical power directly to the appliances through three standard, north american u-ground receptacles. Never try to use the inverters with any 12-vdc-power source that uses a positive ground. Most modern vehicles, boats and aircraft use negative ground system...
Appliance amps@ watts@ 110vac 110vac computer and monitor 4 450 portable vacuum 4.6 540 8-cup coffee maker 5.5 650 electric trimmer 5.5 660 1/2" hammer-drill 5.5 660 reciprocating saw 6 720 vacuum cleaner 7.2 865 1-1/8" rotary hammer 7.8 940 1/6 h.P. Submersible sump pump 8 960 compact microwave ove...
5.0 installation the inverter will provide you with up to 1000 watts of continuous, elec- trical power (2000 watts peak) at 110 vac when powered by a 12 vdc source such as is found in a vehicle or multiple battery configuration as shown in figure 7. This manual does not describe all of the possible ...
4.3 battery operating time figure 6 is a set of curves that show how appliance load in watts or in amperes affects operating time. These curves are only estimates of operating time, dependent upon: • the condition of the batteries • the state of charge on the batteries • the amount of other dc appli...
