Vega plicscom Operating Instructions Manual - page 20
20
6 Set up Bluetooth connection with smartphone/tablet
PLICSCOM •
36433-EN-180221
Information:
Bluetooth communication functions only if the actual sensor PIN dif-
fers from the default setting "0000".
6.2 Connecting
Start the app and select the function "Setup". The smartphone/tablet
searches automatically for Bluetooth-capable instruments in the area.
The message "Searching …" is displayed.
All found instruments will be listed in the adjustment window. The
search is continued automatically.
Select the requested instrument in the device list.
The message "Connecting …" is displayed.
Forthefirstconnection,theoperatingdeviceandthesensormust
authenticate each other. After successful authentication, the next con-
nection functions without authentication.
iOS
During the pairing process, the following message is displayed: "Pair-
ing request (Bluetooth), e.g. 12345678 wants to pair with your iPad".
Press "Pair".
For authentication, enter in the next menu window the 4-digit PIN
which is used to Lock/Unlock the sensor (sensor PIN).
Android
The pairing runs automatically. For authentication, enter the 4-digit
PIN which is used to Lock/Unlock the sensor (sensor PIN).
Note:
If an incorrect sensor PIN is entered, the PIN can only be entered
again after a delay time. This time gets longer after each incorrect
entry.
The message "Waiting for authentication" is displayed on the smart-
phone/tablet.
After connection, the sensor adjustment menu appears on the re-
spective operating device. The display of the display and adjustment
module shows the Bluetooth symbol and "connected" with sensors
of the later generation. Sensor adjustment via the keys of the display
and adjustment module itself is not possible in this mode.
Connecting …
Authenticate
Connected