Veho MUVI Atom User Manual - page 5
5
Veho MUVI ATOM Operation
1. Charge your Veho MUVI ATOM by connecting the USB cable to your PC/Mac/Notebook or
using an (optional) Veho USB Adapter and the mini USB jack on the base of the MUVI ATOM.
While charging the MUVI ATOM Red LED indicator will flash slowly. Once fully charged the red
LED indicator will stop flashing and remain constant.
2. Insert the micro SD card into the slot on the right side of the MUVI ATOM.
3. Power the MUVI ATOM on by the switch on the left hand side of the MUVI ATOM. If no micro
SD card has been inserted then the green LED indicator will flash green quickly. When the
MUVI ATOM becomes low on charge the red LED Indicator flashes quickly for 30 seconds and
then turns of the unit.
4. If the MUVI ATOM has good charge but has not been used in 2 minutes it will switch to
standby mode.
5. To record manually once MUVI ATOM is powered on press the record button. The green LED
indicator will switch on and flash slowly. If the MUVI ATOM is in standby mode then press
record once to re-activate and start recording again. Press record button to stop recording
and the MUVI ATOM footage will be saved to SD card as *.avi file.
6. If the LED is solid green then the micro SD card is full and you will need to move your MUVI
ATOM footage to a PC or connect to PC to delete footage.
E
n
g
lis
h