Velleman CAMSETW16 User Manual - page 5
CAMSETW16
00 (12/08/2008)
5
8.
Mounting
•
The camera can be mounted against the wall or the ceiling or simply placed on a desktop
using the universal bracket (5).
Note: the hood (2) can be removed by sliding it forward. To remount, start at the rear end
of the camera and slide forward until the holes in the hood (2) and camera are in line.
•
When mounted on the ceiling, the universal bracket must be place on the top of the
camera (closest to antenna (1)). To do this, unscrew the universal bracket (5) from the
housing and screw it in the opening on top of the camera.
•
The receiver should be placed horizontally antenna pointing upwards. The antenna can be
rotated to improve signal reception.
9.
Operation
•
Mount the camera in a location that needs to be monitored.
•
Apply power to the camera. Insert the jack from the adapter into the DC power jack (8)
of the camera.
•
When necessary (interference with other devices occurs or multiple cameras are used),
set the channel by opening the channel switch cover (6). There are 4 channels possible,
default channel is 1. Close the switch cover (6) after setting the switches.
•
Point the antenna (16) of the receiver upwards. The antenna can be rotated in either
direction. Do not force the antenna.
•
Connect the receiver to a monitor or TV via the video and audio output jacks (9, 10 &
11).
Note: YELLOW plug = video, RED plug = audio (R), WHITE plug = audio (L)
•
Connect the DC power adapter to the DC power jack (12).
•
Switch the power ON/OFF switch (15) to the ON-position.
•
Power on the monitor or TV and select AV mode.
•
The system is capable to support 4 cameras at the same time. Select the channel via the
channel select button (17). The current channel is indicated in the channel display (14).
•
Press and hold the channel select button (17) for 3 seconds to go in loop mode; every
channel will be shown for 5 seconds.
•
Adjust the brightness, contrast and colour settings of the monitor or TV to get the best
display result. Changing receiver and/or antenna location might improve the image.
•
In dark environmental conditions, the built-in Infra-Red lights (4) will automatically
become active. In this night vision mode, the image will become monochrome (black and
white). The night vision range is limited to 7m.
•
Use of the remote control:
Channel 1
Channel 2
Channel 3
Channel 4
2,414MHz 2,432MHz 2,450MHz 2,468MHz
Remote
18. Lock/unlock key
19. Channel selectors
20. Loop key
21. Channel up/down key