Velleman CARSFM2 User Manual - page 6
CARSFM2
Rev. 02
23/12/2010
6 ©
Velleman nv
Note: this feature only works when supported by the car radio!
Briefly press the MENU/REPEAT button 5 times. Use the
or
button to
select sync mode.
Music input
• There are 3 ways to provide music files to the transmitter (see §7: file
organization):
1. using an SD-card. Slide the SD-card in the SD-card slot [C] (pins facing
down).
2. via a USB device. Connect the USB device to the USB connector [D].
3. through the 2.5mm mini jack. Plug the 2.5mm plug into the mini jack [E].
• Press and hold the MEM/SD-USB button for ±2s to switch between SD and
USB input.
Playback
• Set the volume on the transmitter to an average level. Press the
MENU/REPEAT button twice followed by the
or
buttons (7 levels). Use
the volume control on the radio to get the best signal quality.
• Press the button, to toggle between pause and play mode. In play mode,
press the
or
buttons
to skip to previous or next track. Press and hold
or
for ±2s to skip to previous or next folder (see §7: file organization).
• In playback mode, press and hold the button for ±2s to switch the
transmitter display between frequency or remaining play time.
• In playback mode, pressing and holding the MENU/REPEAT button for ±2s will
scroll through playback modes:
1x Shuffle
mode
2x Repeat
current
track
3x Repeat
current
directory
4x
Normal playback mode
• 7 frequencies can be stored for quick access. First select the desired
frequency, than press the MEM/SD-USB button. Use the
or
buttons to
select a memory address (1~7).
• To recall a stored frequency, press the MEM/SD-USB button repeatedly until
the desired frequencies is shown on the display.
RDS
• For music tracks that are provided through the USB-port and that contain an
ID3-tag, a car radio with RDS (Radio Data System) functionality will show the
track information on its display.
• Briefly press the MENU/REPEAT button 3 times. Use the
or
button to
select the RDS display method and press the MENU/REPEAT button again.
NOR: display shows 8 characters
SCR: display scrolls with 1s interval
• Briefly press the MENU/REPEAT button 4 times. Use the
or
button to
select the interval time under normal RDS display mode (2~6s) and press the
MENU/REPEAT button again.
Remote control
• Refer to the overview under §5 for key functions.
• Use the fast reverse () or fast forward () buttons to scroll back or forward
through the current track at increased speed (2x, 5x or 10x).
• To recall a stored frequency, press the FREQ HOTKEY button repeatedly until
the desired frequencies is shown on the display.
• To repeat only a certain section of a track, press the A button at the desired
starting point and press the B button at the desired end point. The section
between A en B will be repeated until the B button is pressed again.