Velleman CCTVPROM9 Quick Installation Manual - page 5
CCTVPROM9
23/11/2010
©Velleman nv
5
•
VGA interface built-in
•
backup function: supports USB 2.0 flash drive backup
•
remote surveillance on mobile phone via 3G/GPRS or on PC through internet connection
•
motion trigger recording
•
multi-language OSD: English, French, Dutch, German, Portuguese, Spanish, Czech, Hungarian, Greek,
Italian, Arabic, Polish, Vietnamese and Chinese
•
A/V support: supports 4 audio inputs and 1 audio output for sound recording
•
supports SATA HDD
•
PTZ control: supports PELCO-D protocol
•
alarm I/O: 4 inputs, 1 output
•
supports daylight-saving function
•
supports manual / timer / motion / network recording functions
•
system auto recovery after power reconnected
•
supports TCP/IP, PPPoE, DHCP and DDNS network connection
•
optional monitor (not incl.): MONSCA4, MONSCA5
•
4x IR bullet colour cameras
5. Overview
Refer to the illustrations on page 2 of this manual.
Front panel
LED
indications
HDD
reading or recording activities on the hard disk
POWER
DVR power is on
1 ~4
Press a button to select the corresponding channel.
4CH: Press to show the 4 channel display mode.
PLAY
Press to play the recorded video.
LIST
List the information of the recorded files.
QUICK SEARCH / RECORD / MOTION / ALARM / TIMER / FULL LIST
ENTER
Press to confirm settings
MENU
Press to enter the main menu.
SLOW
In playback mode, press to play the recorded file slowly.
ZOOM
Press to enlarge the image of the selected channel.
AUDIO
= SLOW + ZOOM
Press SLOW and ZOOM simultaneous to select live or play-back sounds.
SEQ
Press to show all screens sequentially in full screen mode. Press again to quit.
PAUSE
S / +
Press to pause, press again to continue playback.
Press to move up (S) or increase value (+)
STOP
T / -
Press to stop playback.
Press to move down (T) or decrease value (-)
REW
e
Press to rewind.
Press to move left (
e
).
FF
f
Press for fast forward.
Press to move right (
f
).
USB
Connect a USB flash drive for video backup to this USB port.
Connect a USB mouse to this USB port.
Note: do not connect two USB flash drives or USB mice at the same time.
rear panel
VIDEO IN
4 video input channels to connect 4 external video sources.
MONITOR
connect a CRT monitor to this output
AUDIO IN
1 audio input channel to connect an external audio source e.g. from a camera with audio.
AUDIO OUT
1 audio output to connect to an audio device, e.g. a speaker (mono).
LAN port
Connect the DVR to a local network by plugging a network cable into this port.
VGA
connector for video monitor
EXTERNAL I/O
use a 9 pin DSUB connector to connect external signals e.g. alarm, sensor, ...
19V DC
Power supply input.
6. Hardware setup
Connecting a video monitor
•
Obtain a suitable monitor (not included) and connect it to the BNC or VGA video output port on the back of
the DVR.
Note: when both a CRT and VGA monitor are connected, press and hold the e button during start-up to
force the output to the CRT monitor port.