Velleman SP200B Operating manual - page 3
SP200B
VELLEMAN
3
OPERATING MANUAL SP200B
REMOTE CONTROL AUTO ALARM SYSTEM
INTRODUCTION
This alarm system will provide years of dependable operation. Yet, quality and
longevity of the system are determined by the installation. For information on
operating the system, read the operation manual.
GENERAL SPECIFICATIONS :
Power Requirements
+ 12 Volts & Negative Ground
Fuse Ratings - Red Power wire -
3 Amps
Current Consumption
Less than 10mA Stand By
Arming Delay
3 seconds
Alarm Timer
60 seconds with 2 Cycles Limitation
Triggers inputs
Minus. 0.6 of volt. drop.
Shock sensor
Receiver channel
3 Channels
Learning limitations
2 Transmitters
INSTALLATION
A. MOUNTING THE SIREN
1. In the engine compartment, place the siren in a location suitable for best
sound results. Be careful not to mount the unit near exhaust manifolds or
other "hot" equipment and moisture area.
NOTE : Preferred siren position is facing forward (toward front of vehicle).
Siren should not face up.
2. Mark and drill two 3/16" holes to screw on the mounting bracket. With the
screws and lock washers provided, mount the bracket to the vehicle.
3. After mounted the bracket, mount the siren to the bracket with the bolts,
washers and lock washers provided. Adjust the siren angle and tighten bolts.
B. DECALS
Peel the decals from the paper backing and apply them to the inside of your
vehicle's window. These are an effective deterrent to thief. Most thieves pass by
vehicles that equipped with security system.