Velleman SP200B Operating manual - page 5
SP200B
VELLEMAN
5
PROGRAMMING AND ADJUSTMENT
After all wiring completed, follow the steps to program transmitter code, siren
and shock sensitivity.
A. PROGRAMMING TRANSMITTER CODE
Programming the transmitter codes, when the alarm completely installed. Only 2
transmitters can operate with a single alarm unit.
Steps are : Disconnect power to alarm, after 10 seconds reconnect the power.
Programming transmitters
Confirmation of
programmed
Press first transmitter's button I
One chirp from the siren.
Press second transmitter's (optional) button I within
5 seconds after programmed first transmitter.
One chirp from the siren.
Attention! If this alarm loses power, it will not retain the transmitter's code. Re-
programming is necessary, and the procedure is the same as above. After
reconnecting the power, this alarm's siren preset on multi-siren tone, and shock
sensor's sensitivity preset on level 3.
B. SHOCK SENSOR SENSITIVITY ADJUSTMENT & TESTING :
ENTER PROGRAMMING MODE :
1. Upon disarm, within 10 seconds, press both buttons together for 2 seconds.
You will hear a confirmation chirp, and now it is on programming mode.
2. Press button II to enter choosing shock sensitivity. By pressing button II again
you can scroll through 8 levels and 8 corresponding tones. The higher the
pitch of the tone the more sensitivity the alarm is to shock.
button I
button II
LED
order code : 600-2N