Vt-ssd soldering-/desoldering station soldeer-/desoldeerstation station de soudage/dessoudage lÖt- und entlÖtstation user manual gebruikershandleiding manuel d’utilisation gebrauchsanleitung.
Vt-ssd gb 1 vt-ssd --- soldering / desoldering station 1. Introduction congratulations ! You have selected the ideal solution for all your soldering/desoldering applications ! We are confident that the versatility and the many special features of the vt-ssd will satisfy your every need. We advise yo...
Vt-ssd gb 2 this soldering/desoldering station is designed to meet the present and future needs of the electronic production industry. The vt-ssd is engineered to meet the stringent demands of hobbyists, maintenance personnel and production people alike. 4. Operating temperature soldering the most c...
Vt-ssd gb 3 operating procedure for soldering and desoldering activities general 1. Make sure the unit’s power switch is in the "off"-position. 2. Plug in the soldering and desoldering handpiece and connect the vacuum tube to the vac- connection. 3. Connect the ac power cord to the mains inlet. 4. P...
Vt-ssd gb 4 soldering activities : important note do not use temperatures in excess of 410°c (770°f) for normal soldering and desoldering purposes. The device can be used at higher temperatures for short periods of time. Exercise great caution when doing so. 6. Common causes for tip failure - the te...
Vt-ssd gb 5 8. Loss of suction : possible causes use the procedure outlined below to determine whether the loss of suction is due to the tip, to the solder collector, the tube or the in-line filters. Caution : the main power switch should be in the "off"-position before attempting these procedures. ...
Vt-ssd gb 6 fig. 8 fig. 9 fig. 10 11. Procedure for cleaning the solder collector caution : put the main power switch in the "off"-position and allow the device to cool first. 1. Hold the soldering iron as shown in fig. 8. Press and turn the switch at the butt of the iron. 2. Be careful not to burn ...
Vt-ssd gb 7 12. Replacement of filters a. Filter of the solder collector (desolfilt) 1. Make sure that the iron and the filter have cooled sufficiently. 2. Point the soldering iron slightly upwards while pressing and turning the red switch on the butt of the iron. 3. Remove the solder collector (fig...
Vt-ssd gb 8 2. Replace the fillings of both filters as shown in fig. 18. Note : use a desoldering tip with a Ø of 1.2mm (bitdest2). Fig. 18 to station to iron fillings bitdest2.
