Velleman WC3320 User Manual - page 4
WC3320
Rev.
02
02/12/2009
©Velleman
®
nv
4
6.
Overview
Refer to the illustrations on page
2
of this manual.
Clock
4
LCD battery compartment
1
suspension
5
LCD reset
2
clock movement
6
outdoor temperature/trend
3
LCD controls
7
indoor temperature/trend
Sensor
S4
channel selector
S1
LCD
S5
°C/°F selector
S2
suspension
S6
battery compartment
S3
test button
S7
foldable stand
clock movement (2)
C
manual set
A
reset pins
D
battery compartment
B
forced receiving
E*
protection pin*
* Depending on the model, this pin may or may not be present.
LCD controls (3)
H
alarm button
F
channel selector
I
up-button
G
max/min button
J
down-button and °C/°F selector
LCD display (6 & 7)
N
link indicator
K*
channel indication
O
max/min indicator
L
trend indicator
P
°C/°F indicator
M*
alarm indicator
Q
temperature indication
* Only on the OUTDOOR display (6).
7.
Clock operation
Refer to the illustrations on page
2
of this manual.
Important:
Depending on the model, a protection pin may still be present to secure the movement.
Remove the protection pin before first use! Dispose of it in a safe way.
Do not
attempt to reinsert the pin afterwards as this will surely damage the clock.
•
Insert a battery in the battery compartment (see §10). All hands will move forward towards
12:00.
Note:
when the original position of the second hand is between 11:55 and 12:00, the
second hand will make a full turn before stopping at 12:00. The same happens with the minute
hand when the original position is between 11:52 and 12:00.
•
Choose a location for the clock (refer to §5).
•
Wait until the clock receives the synchronization signal from the master clock. This might take
up to 15 minutes. Note that the received signal is usually stronger at night time.
•
Once synchronized, the hands will start moving towards the correct time.
•
When the clock doesn’t receive the radio-signal, it will start running showing the wrong time.
However, it will keep attempting to synchronize.
Manual setting
•
It is possible to set the time manually, e.g. for use in places where no radio-signal is received.
•
Press and hold the manual set button
[C]
. After ±3 seconds the minutes and hour hands start
moving. Hold down the manual set button
[C]
and release a couple of minutes before desired
time setting. Press the manual set button
[C]
repeatedly until the desired time indication is
reached. When no press is detected within 7 seconds, the clock starts running.
Forced receiving
•
To force the clock to synchronize, press and hold the forced receiving button
[B]
for ±3
seconds. The current time is stored in memory and all hands will start moving towards 12:00.
The clock attempts to synchronize with the master clock.