Veloretti Bicycle Assembly Manual - Before You Hit
Optional
Front carrier
You can easily mount the front carrier onto the front wheel. Loosen
the screws fi rst (step 2,5) to mount the front carrier. Make sure that
the steel safetypin stays at its place before you tighten the screw.
The top side of the front carrier is mounted to the stem of the bike
with the included assemblyset. The front carrier should be mounted
as shown on the photo below. Take the screw all the way through the
carrier and tighten the screws on the backside to avoid the carrier
from rattling.
Before you hit
the road...
Almost there! Now you’re done assembling
there are a few very important things to con-
sider regarding:
safety. Your tires could use
some air too, by the way...
So before you hit the road, make sure you clo-
sely read this page and dubblecheck if your
Veloretti is city-proof!
Pump it up!
Cycling is a lot easier - and more fun - when there is air in the tires.
Pump up your tires to the amount of pressure that you like best. Use
the copper valve that is on one of the tires and make sure that you
unscrew the small nut inside the valve a little to permit airfl ow. After
the tire is infl ated tighten the small nut again and use the copper valve
to pump up the other tire of your bike. We recommend to put enough
air in your tires, as this will improve your ride enormously!
Final check
Double check if all the bolts are tight securely and if all components
are undamaged. Pay close attention to the bolts at the front wheel
and make sure both the steer and saddle are tightened.
Finally, install the included refl ector set in order to meet the safety
regulations!