18” electric fireplace heater owners manual model bych-18 only use this insert as described in this manual. Any other use is not recommended by the manufacturer, and may cause fire , electric shock , or other personal injury . Warning! Read and understand this entire owner’s manual, including all sa...
2 important safety information! Warning always keep electric cords , home furnishings , drapes , clothing , papers , or other combustibles at least 3 feet (0.9m) away from the front of this insert , and away from the bottom, sides, and rear of this insert. Do not place the insert near a bed because ...
3 warning risk of electric shock ! Do not open! No user-serviceable parts inside! Always disconnect this unit from the power supply before performing any assembly or cleaning, or before relocating the electric fireplace. Always store this insert in a dry location. Never use the fireplace if it has b...
4 preparation a complete electric fireplace heater should consist of two parts; the wooden mantle and the fireplace heater. Each is packed in a separate carton. Always use the fireplace heater with the wooden mantle. Remove all parts from the carton and place them on a clean, soft, dry surface. Chec...
5 assembly step 1. Thread two frame screws (2) through each plastic connector (1) and into pre-drilled holes in panels c, c, d, and e. Secure with phillips screwdriver. Do not over-tighten. Step 2. Thread two frame screws (2) through each joiner plate (3) and into pre-drilled holes in header panel f...
6 step 3. Thread a frame screw (2) through each plastic connector on side panels (c) and into pre- drilled holes in front panels d and e. Secure with phillips screwdriver. Do not over-tighten. Step 4. Thread a frame screw (2) through each plastic connector on panel assemblies (c/d and c/e) and into ...
7 step 5. Align joiner plates (3) of header panel (f) with panel assemblies (c/d and c/e). Thread a frame screw (2) through each joiner plate hole and into pre-drilled holes in front panels. Secure with phillips screwdriver. Do not over-tighten. Step 6. Set top panel (a) on top of side panel assembl...
8 insert installation always unplug this fireplace insert before installing, cleaning, or relocating it. Failure to do so could result in electric shock , fire , or personal injury . Step 1. Slide electric fireplace insert carefully into mantel from behind until flange is flush with mantel wall and ...
9 operation read and understand this entire owner’s manual, including all safety information on pages 2 and 3 , before plugging in or using this product. Failure to do so could result in electric shock, fire, serious injury, or death. Power make sure the on/off switch, located on the control panel, ...
10 notice when the insert is first turned on, a slight odor may be present. This is normal and should not occur again unless the insert is not used for a long period of time. Notice the light bulbs may become loose during shipping. If the flame effect does not operate properly, check the light bulbs...
11 changing the light bulbs there are two (2) 40w type b-10 light bulb located under the log bed. Always use care when handling glass! Although this is safety glass it may break if bumped, struck or dropped. Never operate this product with missing or broken glass . 1. Carefully unscrew both screws a...
12 warning! No other servicing should be performed by the consumer. Do not attempt to service the unit yourself. Limited warranty this warrants to the original purchaser that this product is free from defects in material and workmanship as of the date of purchase and that it will, under normal use a...
