Vendor BYCH-18 Owner's Manual - Changing The Light Bulbs
11
Changing the Light Bulbs
There are two (2) 40W Type B-10 light bulb located under the log bed.
ALWAYS use care
when handling
glass!
Although this is safety glass it may break if
bumped, struck or dropped.
NEVER
operate this product with
missing or broken glass
.
1. Carefully unscrew both screws
and remove the glass panel.
2. Remove the screw at each end
of the log bed.
3. Lift out the log bed to
access the light bulbs.
4. Loosen and remove the burnt out bulb(s). Always replace with 40W Type B-10 bulbs.
5. Replace log embers and glass panel. Securely tighten the screws, but DO NOT over-tighten.
AVOID burns! Light bulbs
can become
extremely hot during use! ALWAYS wait at
least 15 minutes after turning off
the unit
before removing
the light bulbs
.
NEVER
exceed
the recommended bulb wattage (
40W
)! Use of a
higher rated bulb
may
result in a fire causing personal injury and/or property damage!
Maintenance
Risk of
electric shock
!
DO NOT OPEN!
No user-serviceable parts inside!
ALWAYS
turn the fireplace insert
OFF,
unplug the power cord from the outlet, and
allow the unit to cool
before performing maintenance, cleaning, or moving this fireplace.
Failure to do so could result in
electric shock, fire, or personal injury
.
Electrical and Moving Parts:
•
The fan motors are lubricated at the factory and will not require lubrication.
•
Electrical components are integrated in the fireplace and are not serviceable by the consumer.
Storage:
•
Store insert in a clean dry place when not in use.
Replacement parts:
•
Use only replacement parts supplied by the manufacturer. Use of any other parts, or modifying
the fireplace in any way, will void all warranties.
Meijer.com