Venini 60 cm Series User And Installation Instructions Manual - page 14
13
ELECTRICAL CONNECTION
Before connecting the appliance, make sure the supply voltage marked on the Rating Plate
corresponds with the mains supply voltage.
WARNING – THIS APPLIANCE MUST BE EARTHED
This appliance should be wired into a 16A double pole switched fused spur outlet having 3mm
contact separation and placed in an easily accessible position adjacent to the appliance.
IMPORTANT
The wires in the mains supply lead are coloured in accordance with the following code:
Green and Yellow
-
Earth
Blue
-
Neutral
Brown
-
Live
The wire coloured Green and Yellow must be connected to the terminal marked ‘E’ or with the
earth symbol (
) or coloured green and yellow.
The wire coloured Blue must be connected to the terminal marked ‘load’ and ‘N’.
The wire coloured Brown must be connected to the terminal marked ‘load’ and ‘L’.
Care must be taken to ensure that the temperature of the mains supply lead does not exceed 50
C.
REPLACING THE MAINS LEAD
In the event it is necessary to replace the mains supply lead, proceed as follows:
1.
Disconnect the appliance from the supply, undo the fixing screws and remove the back panel.
2.
Undo the clamp screws and terminal screws to release the existing lead.
Assemble the replacement lead, that must conform to the specification listed in the
Technical Data, ensuring the correct colour code connection and that all screws are
tightened correctly.