Venmar Connaisseur CIC700 Series Installation Instructions Manual - 1. Install Ductwork (
Installation over a gas range:
Refer to gas range manufacturer’s guidelines for
the recommended CFM. If two CIC700 Series
range hoods are required, the minimum space
between the hoods should not be less than 1”.
HH0154A
1" M
IN
.
- 4 -
1. INSTALL DUCTWORK (
CONT
’
D
)
2. PREPARE THE INSTALLATION
When performing installation, servicing or cleaning the unit, it is recommended
to wear safety glasses and gloves.
WARNING
!
NOTE: Before proceeding to the installation, check the contents of the box. If items are missing
or damaged, contact the manufacturer.
Make sure that the following items are included:
- Hood
- Accessories
• Decorative flue assembly (lower and upper flues)
• 2 Shielded halogen bulbs (120 V, 50 W, MR16 with GU10 base)
• 2 Baffle filters
• 4 Filter knobs with screws (taped inside the hood)
• 1 Ceiling mounting bracket
• 8 Angle brackets
• 8” Adapter/Damper (in a separate box)
• Installation manual
• Bag of parts including: 2 wire connectors, 1 wire clamp,
8 no. 10 x 1½" wood screws, 8 washers, 2 no. 8 x 1/2" quadrex screws,
10 no. 8 x 3/8" quadrex screws, 17 no. 10-32 locknuts, 50 no. 10-32 x 1/2"
quadrex screws
Parts sold separately:
- Ducts, elbows, wall and roof caps.
- Optional flue extension for 10-ft. ceilings model no. 19325.
- LinkLogic® remote control (model no. ACW1WH).
- Glass panels for CIC700I16WG model (see service parts list on page 20).
NOTE: During installation, protect countertop and/or cooktop.