Venmar Connaisseure C700 SERIES Installation Instructions Manual - 11. Care (

11

11. CARE (

CONT

'

D

)

G

LASS

PANEL

Hot water with mild soap or glass cleaner is all that is usually needed.

When using mild soap, rinse with clear water. Wipe dry with a clean, soft cloth to avoid water marks.

Avoid when choosing a detergent:

-  Any cleaners that contain 

bleach

 will attack stainless steel.

-  Any products containing: 

chloride, fluoride, iodide, bromide

 will deteriorate surfaces rapidly.

-  Any combustible products used for cleaning such as 

acetone, alcohol, ether, benzol

, etc., are 

highly explosive and should never be used close to a range.

12. OPERATION

Always turn your hood on before you begin cooking to establish an air flow in the kitchen. Let the 

blower run for a few minutes to clear the air after you turn off the range.

HC0052

A

B

C

D

A. D

ELAY

 B

UTTON

/C

ONTROL

 L

OCK

 (D

OUBLE

 F

UNCTION

 B

UTTON

):

i.  When a blower speed is selected, press this button to activate the delay function. The 

delay button will light to its high intensity, then to its mid intensity to indicate this function 

is activated; the selected blower speed button will alternate every 2 seconds from its high 

intensity to its mid intensity. The blower will continue to operate for 5 minutes and will 

stop automatically. Selecting another speed while the delay function is activated will not 

deactivate the function or reset the timer. To cancel the delay function, press the delay 

button once again or the selected speed button which last case will also turn the blower off.

ii.  When blower is off, it is possible to lock the control interface in order to clean the glass 

panel.

To lock the control interface: Press and hold the button for 3 seconds. The button will light 

to its high intensity and flash three times, it will then stay on its mid intensity to indicate that 

the control interface is locked.

To unlock the control interface: Press and hold the button for 3 seconds. The button will light 

to its high intensity and flash 3 times, it will then fade out to its low intensity to indicate that 

the control interface is unlocked.

B. S

PEED

 S

ELECTION

 B

UTTONS

:

Press the button corresponding to the desired blower speed (from 

1

 for low speed to 

4

 for 

high speed). The chosen speed button will light to its high intensity then fade to its mid 

intensity. To turn off the blower, press once more on the corresponding blower speed button; 

the button light will fade to its low intensity.

NOTE:  When blower is off, pressing on blower speed 

1

 button will cause the blower to start 

on second speed for a very short lapse of time, and then resume on speed 

1

.