Venmar Jazz VJ70524SS Installation Manual - 7. Install The Hood
HO0104
BE CAREFUL when installing the decorative flue and hood, they may have sharp edges.
1. Lay the back side of the hood flat on a table. Use a piece of cardboard to avoid
damaging the table or the hood.
2. Remove the grease filters by pulling down the metal latch tab and
tilting filters downward to remove.
3. Align the hood and center it above the hood mounting bracket.
Gently lower the hood until it securely engages the bracket.
4. With the hood hanging in place, drill through both holes located in the
inside lower back of hood (
Fig. 1
) using a 5/16” drill bit. Insert the included drywall
anchors into the drilled holes (one for each hole). Install (2) washers and
(2) no. 8 x 1¼” mounting screws into the drywall anchors. Verify that the hood is
centered and leveled. Tighten all screws completely.
5. Reinstall grease filters by aligning rear filter tabs with slots in the hood.
Pull down the metal latch tab, push filter into position and release.
Make sure filters are securely engaged after installation.
6. Install 6” round adapter/damper on top of the hood using (4) no. 8 x 7/16” mounting screws.
7. Remove protective plastic film covering the lower flue only.
8. Install the lower flue bracket to its flue using (2) no. 8 x 7/16” mounting screws, make
sure that the slots point up (
Fig. 2
).
9. Carefully place both flues into the recessed area of hood top. Slightly slide up the
upper flue to avoid any damage while placing the lower flue to the hood top.
10. Slide a 6” steel round duct over the adapter/damper (
Fig. 3
). Use duct tape to seal
the joint.
11. Plug hood power cord into the outlet.
12. Slide up the upper flue until it is aligned with its mounting bracket. The bracket
should be inside the flue. Secure the upper flue to its bracket using
(2) no. 8 x 7/16” mounting screws (
Fig. 4
).
13. Remove protective plastic film covering the upper flue and the hood.
7. INSTALL THE HOOD
CAUTION
DO NOT REMOVE the protective plastic film covering the decorative flue (upper and lower) and the hood yet.
-6-
6
”
R
OUND
DUCT
HJ0012A
Fig. 3
Fig. 4
WARNING
!
HD0
3
4
8
A
H
OLE
S
LOCATION
10
”
Ø 5/16
”
TYP
.
M
OTOR
/B
LOWER
A
SS
EMBLY
S
IDE
VIEW
I
N
S
IDE
BACK
OF
THE
HOOD
Fig. 1
U
PPER FLUE MOUNTING BRACKET
F
RONT VIEW
U
PPER
FLUE
HO0114
Fig. 2
L
OWER FLUE MOUNTING BRACKET
B
ACK VIEW
L
OWER
FLUE
S
LOTS UP