VENTCROFT ICU freedom User Manual - 5.0 Display References
Draft 3
Printed: 09/07/2003
Page 20
doc: icu_kit_user_maunul_090703.doc
5.0 Display References
LED’s and information Display.
5.1 General Display Indication
LEDs illuminated
Display shows
Indicates
z
Mains
Illuminated
Mains
connected
}
Mains Flashing
Mains failure and on battery back up
“
0 0
“
Day
/
un-set
“
e
“
Incorrect code entry
“
0 0
“
Flashing
Un-set with no activations
“
F U
“ Flashing
Indicates the control unit is full setting
“
p 1
“
Flashing
Indicates the control unit is Part 1 setting
“
p 2
“ Flashing
Indicates the control unit is Part 2 setting
“
p 3
“ Flashing
Indicates the control unit is Part 3 setting
“ “
System Armed, Full or Part
5.1 Alarm Activation Display Indication
LEDs illuminated
Display show
Activation type
z
Intruder
“
0 1 – 1 6
“
wireless detector activated
“
d 1 -d 4
“
Direct wired detector activated.
z
Alarm
“
P A
“
Wireless personal attack (PA) button was activated.
z
Tamper
“
0 1 – 1 6
“
The tamper switch on this wireless detector was activated.
z
Tamper
“
c u
“
The tamper switch on the Control Unit was activated.
z
Tamper
“
s b
“
The tamper switch on the external Siren Box was activated
or – Hold Off or RTN wires broken.
z
Tamper
“
d t
“
The Tamper switch on one of the Direct wired was activated.
z
Interference
“
I n
“
Jamming or Interference of the radio transmissions was
detected.
z
Tamper
“
r P
“
The tamper switch on the remote key pad was
activated.
8 8
z z z z z z
Mains LED
z
illuminates constantly on presence
of mains
}
Flashing on battery back up; mains
fails.
Interference
z
Illuminates with Radio interference
or potential jamming detected
Fault
z
illuminates if the “Auxiliary” fuse
(f1) fails or if a PIR looses connection
with the control unit”
Low Battery
z
Illuminates warning of a low battery
Tamper
z
Illuminates to show detection of
tampering of a wired or wired
devices
Alarm
z
Illuminates to show an alarm activation,
intruder or PA of a wired or wired
device.
LED’s
Display