45812a printed in canada 27‐05‐2015 installation and operation manual me150 safety tested according to ulc s610 and ul 127 standards by an accredited laboratory e.P.A. Standards exempt www.Occanada.Com manufactured by: stove builder international inc. 250 rue copenhague, saint‐augustin‐de‐desmaures ...
2 me150 ‐ installation and operation manual thank you for choosing this ventis fireplace as one of north america’s largest and most respected wood stove and fireplace manufacturers, stove builder international takes pride in the quality and performance of all its products. We want to help you get ma...
Me150 ‐ installation and operation manual 3 table of contents 1 introduction ....................................................................................................................... 4 1.1 me150 wood fireplace specifications ................................................................
4 me150 ‐ installation and operation manual 1 introduction this manual contains all the information required for safe, efficient installation and use of your ventis fireplace. Read carefully all the instructions contained herein and keep this manual handy so you may refer to it whenever necessary. B...
Me150 ‐ installation and operation manual 5 1.2 views with measurements.
6 me150 ‐ installation and operation manual 2 installation this fireplace is designed and approved for installation with the brand of chimney mentioned in table 1 with a minimum of 15’ (4.6 m) and maximum of 45’ (13.5 m) in height. No other device must be added to the chimney connected to the firepl...
Me150 ‐ installation and operation manual 7 2.1 fireplace installation 1. Before beginning installation, remove the fireplace trim to protect it from damage. The fastening screws are located behind the upper and lower louvers. Make sure no masonry products or acids come into contact with the trim as...
8 me150 ‐ installation and operation manual 7. The opening must be at least 24” (610 mm) away from any wall at a right angle with the appliance’s face (see figure in section 4: fireplace finish). 8. Place the appliance in the desired location. It must directly abut against the finished wall and not ...
Me150 ‐ installation and operation manual 9.
10 me150 ‐ installation and operation manual 3 venting system 3.1 general information the venting system is the engine that drives your wood heating system. Even the best fireplace will not function safely and efficiently as intended if not connected to a suitable chimney. The heat in the flue gases...
Me150 ‐ installation and operation manual 11 5. All chimney installations must include at least one support. Reducing the amount of chimney weight on the fireplace will help avoid the noise created when the fireplace expands. This can be achieved by having the chimney supported by the supports. The ...
12 me150 ‐ installation and operation manual 9. A rain cap must be installed on top of the chimney. Failure to install a rain cap may cause corrosion problems. 10. Cut and frame square holes in all floors, ceilings, and roof that the chimney will go through to provide a 2" (51 mm) minimum clearance ...
Me150 ‐ installation and operation manual 13 3.4 chimney installation instructions always refer to the chimney manufacturer’s installation manual to ensure a safe installation. Some non‐ illustrated parts may be required. Examples of typical chimney installation a to insure a good draft, it is recom...
14 me150 ‐ installation and operation manual direct installation exterior offset installation.
Me150 ‐ installation and operation manual 15 interior offset installation 1. Cut and frame the holes in the ceiling, floor and roof where the chimney will pass. Use a plumb bob to line up the center of the holes. Make sure that the size of the floor and ceiling holes are in accordance with the chimn...
16 me150 ‐ installation and operation manual 4. Every time the chimney passes through a ceiling or a wall, install the appropriate firestop. When you reach the desired height, install the roof support (not illustrated). (refer to instructions included with the support). 5. Then, put the roof flashin...
Me150 ‐ installation and operation manual 17 ** the structural integrity of the floor, wall, and ceiling/roof must be maintained note: the floor and walls below the attic must be insulated using the same insulation..
18 me150 ‐ installation and operation manual 3.5 offset chimney installation table 2 – the minimum system height when using elbows fireplace model me150 wood fireplace chimney model all models listed in table 1 vertical installation 15 ft. (4.5 m) two (2) elbows 15 ft. (4.5 m) four (4) elbows 17 ft....
Me150 ‐ installation and operation manual 19 a insulated wall radiation shield b gypsum board c insulated wall 3.7 chimney support installation universal roof support this support has three possible uses: 1. It must be used on a roof to support the chimney. 2. It may be used on a floor, ceiling or r...
20 me150 ‐ installation and operation manual 4 fireplace finish 1. Combustible materials can be used to finish the fireplace. The framing can be built directly on the sides of the appliance. 2. Side walls can exceed the appliance’s face by a maximum of 6” (152 mm). 3. Adjoining walls may also be bui...
Me150 ‐ installation and operation manual 21 chimney enclosure canada and u.S. Chimney enclosure canada only..
22 me150 ‐ installation and operation manual mantel position mantel lenght min. Distance from fireplace bottom 6” / 152 mm 48” / 1219 mm 8” / 203 mm 50” / 1270 mm 10” / 254 mm 52” / 1321 mm 12” / 305 mm 54” / 1372 mm 4.1 fireplace facing 1. Remove the decorative trim. 2. Install the non‐combustible ...
Me150 ‐ installation and operation manual 23.
24 me150 ‐ installation and operation manual 5 use and safety 1. Teach children fireplace safety rules. 2. Do not use the fireplace under the following conditions: 1. Whenever a firestone is missing or broken. 2. Whenever the ceramic glass is cracked or broken. 3. Never use flammable liquids to ligh...
Me150 ‐ installation and operation manual 25 5.1 manufactured logs do not burn manufactured logs made of wax impregnated sawdust or logs with any chemical additives. Manufactured logs made of 100% compressed sawdust can be burned, but use caution in the number of these logs burned at one time. Start...
26 me150 ‐ installation and operation manual 6 maintenance 1. Clean color trim with soapy water and a soft cloth. Do not use any metal polish or abrasives. 2. Keep the glass relatively clean. Dirty windows will make the fireplace overheat. Wait until the glass is cool before attempting to clean it. ...
Me150 ‐ installation and operation manual 27 pl60004.
28 me150 ‐ installation and operation manual 7 troubleshooting expansion and contraction noises during the heating and cooling cycle are normal. Here is how to prevent smoke flow reversal: position air intake lever to maximum, slowly open the fireplace doors before lighting the kindling, make a torc...
Me150 ‐ installation and operation manual 29 7.1 exploded view for replacement parts.
30 me150 ‐ installation and operation manual 7.2 parts list # item description qty 1 se60079 bottom or top louver assembly 2 2 30472 spring 1/2'' outside dia. X 3''l 4 3 pl59815 exhaust damper rod 1 4 se60063 exhaust damper assembly 1 5 30484 wing nut 1/4‐20 2 6 pl59765 4'' adapter for fresh air int...
Me150 ‐ installation and operation manual 31 ventis limited lifetime warranty the warranty of the manufacturer extends only to the original consumer purchaser and is not transferable. This warranty covers brand new products only, which have not been altered, modified nor repaired since shipment from...
