Vents Micra 60 User manual - page 11
11
www.ventilation-system.com
www.ventilation-system.com
SP3-1 sensor speed switch mounting:
Undo gently the switch front panel latches.
Remove the back panel.
Fix the back panel to the wall through the fastening openings.
Connect the control cable to the sensor speed switch following
the wiring diagram, page 12.
Install the front panel of the speed switch on the latches.
SPEED SWITCH MOUNTING
MAKE SURE THAT THE SPEED SWITCH IS NOT DAMAGED. DO NOT OPERATE A DAMAGED SPEED SWITCH! DO NOT
INSTALL THE SPEED SWITCH ON AN UNEVEN SURFACE! DO NOT APPLY EXCESSIVE FORCES WHILE TIGHTENING
THE SCREWS TO AVOID THE SPEED SWITCH CASING DEFORMATION.
P3-1-300 mechanical speed switch mounting:
Connect the executive element according to the wiring diagram
in page 12 and insert it into the junction box.
Fasten the executive element with two screws from the delivery
set.
Cover the executive element of the speed switch with a
decorative panel and press the latches to fi x the panel.
Route all the required cables and wires to the speed
switch installation place.
Insert the junction box from the delivery set inside the
wall.