Venture Cycle LandRider Assembly Instructions Manual - page 12
S
TEP 12: RETURN BIKE TO UPRIGHT POSITION
Return the LandRider to its upright position if you turned it upside down. Place the Kickstand
down to allow the bike to stand on its own. (See FIG. 17).
STEP 13: CONNECTING PEDALS
IMPORTANT
Please follow connecting Pedal instructions carefully.The Alloy Crank Arm can be damaged if
the Pedal Nut Thresd is not inserted correctly.Gently insert Pedal Nut Thread into Crank Arm hole
and try to turn carefully to get thread started.
There is a Right Pedal marked “R” and a Left Pedal marked “L” (The Pedal marked “R” has right hand
threads and the Left Pedal “L” has left hand threads). If it is a little tricky to get the Pedal Nut Thread started in
the Crank Arm, be patient and try and keep the Pedal straight.
A) Place the Right Pedal into the Right Crank Arm which is the same side as the Chain. Use your fingers to get
started and gently turn the Pedal Nut in a clockwise direction. Using the 15mm wrench provided, firmly tighten
the Pedal Nut.
B) Place the Left Pedal into the Left Crank Arm and using your fingers, gently turn the Pedal Nut in a
counterclockwise direction to get started. Using the 15mm Wrench provided firmly tighten the Pedal Nut. Be
careful not to switch Right and Left Pedals. Right Pedal is only for right and Left is only for left. Make
sure the threads of each Pedal are fully in the Crank Arm and tighten firmly.
Kick Stand
FIG. 17
Right Pedal
Left Pedal
Pedal Nut
Crank Arm
11