Ventus W177 User Manual - page 13
limit. Press “WIND ALARM” to silence the alarm sound. The related high alarm icons will continue to
flash until the alarm condition is no longer met.
High Gust Wind Alarm Setting:
-
Press “WIND ALARM” to show high gust wind alarm display. “ALARM” icons appear in the gust
wind display area
-
Hold “WIND ALARM” button to enter its setting mode and gust wind digits will flash
- Press
“▲”or “▼” to set the value
-
Press “WIND ALARM” to confirm setting and exit
Press “WIND AL
” repeatedly to enable or disable the gust alarm. “
” appears when it is enabled.
Low Wind Chill Alarm
You can also set the monitor to sound an alarm for about 1 minute when the wind chill reaches or falls
below the set limit. Press “WIND ALARM” to silence the alarm sound. The related low alarm icon will
continue to flash until the alarm condition is no longer met.
Low Wind Chill Alarm Setting:
-
Press “WIND ALARM” repeatedly so “ALARM” icons appear in the wind chill display area
-
Hold “WIND ALARM” button to enter its setting mode and the wind chill digits will flash
- Press
“▲”or “▼” to set the value
-
Press “WIND ALARM” to confirm setting and exit
Press “WIND AL
” repeatedly to enable or disable the wind chill alarm. “
” appears when it is
enabled.
MAXIMUM & MINIMUM RECORDS
Press “MEMORY” repeatedly to view the maximum & minimum values of temperature, humidity, heat
index, dew point, wind speed & wind chill readings. The corresponding “MAX” and “MIN” icons will
appear. To clear the memory record, hold “MEMORY” in the max/min display mode
RADIO-CONTROLLED CLOCK
The unit will start synchronizing the radio-controlled clock after battery/adapter installation. The antenna
icon will flash during synchronization. If the reception of radio-controlled time is successful, antenna
icon with full signal strength
will appear on screen. The radio-controlled clock will have a daily
synchronization at 02:03 & 03:03 everyday. Each reception cycle is around 2.5 to 10 minutes.
Antenna icon disappear