Veon SAT101 User Manual - Satellite Scan
Main Menu - Installation - Tuning wizard
-
Satellite Scan
12
Satellite Scan:
From here you can set all the necessary parameters
i.e. LNB settings, DiSEqC, tone switch and
positioner details for each satellite. All options are
displayed along the bottom of the window and
accessed through there. Allows you to scan a
specific frequency.
Pressing the Yellow button and selecting LNB setup brings
you to the page shown in the screenshot on the right hand
side. From here you can set the LNB settings, DiSEqC, tone
switch and positioner details. Press OK to save changes and
go back to the Satellite Scan page.
From here by pressing the Green button will do a full satellite
scan, using the existing TPs or Carriers in the list.
To scan just one transponder, view the transponder list by
using the left/right navigation keys.
The Carrier list page will display as show in the screenshot
below.
Once in the Carrier list, use the up/down navigation keys to
select the desired TP. Then press the Green button to
perform the scan.
To add an additional TP press the Yellow button and select
Add Carrier. Type in the new TP details and press OK to
scan. Press Exit to return to normal viewing once completed.
If your dish is connected and correctly aligned to the
satellite you wish to scan you should get a good signal
Strength and Quality reading at the top of the page. Once
you have these readings you can push the Green button to
start the scan.