VeriFone Everest Plus Installation Manual - Everest Installation Guide
11
Everest Installation Guide
4.
Connect the other end of the ECR Interface Cable into the
appropriate high-speed bus tailgate port on the ECR. The
port to use depends on the configuration of your ECR
system. The Everest Plus terminal usually connects to
IBM slot 2A23, 2A25, 2B23, or 2B25. These slots are on
the back of the ECR and correspond to addresses 0x68,
0x64, 0x69, and 0x65, respectively.
5.
If you have an optional peripheral device with a 6-pin or
8-pin mini-DIN port, such as a printer or check reader,
connect its interface cable to the appropriate mini-DIN
port on the Multi-Port Cable. While there are two side-by-
side ports on one side of the cable — a 6-pin mini-DIN
port and an 8-pin mini-DIN port — only one port can be
used at a time.
6.
Connect the peripheral device to the interface cable, and
then connect the device's power supply.
Figure 5
Multi-Port Cable Connection
3
9
5
4
11
1
A
A
A
A
4
17
17
B
B
B
B
2A
2B
4683-P
IBM ECR
41-pin Connector
Connect Peripheral
SDL
Interface Cable
Port
Multi-Port
Cable
Interface Cable to the
appropriate mini-DIN port