VeriFone Omni 3600 Reference Manual - page 11
O
MNI
3600 T
ERMINAL
AND
O
MNI
3600 B
ASE
I
NSTALLATION
Omni 3600 Terminal
O
MNI
3600 R
EFERENCE
M
ANUAL
11
The Omni 3600 terminal is equipped with a tamper-evident label (on a screw hole
on the case bottom).
Power Port
On the back of the Omni 3600 is one port—the power port. Use this port to
connect the Omni 3600 to the power pack to recharge the battery through the unit
Connect Power Pack
To connect the Omni 3600 terminal to power:
1
Insert the round barrel connector (
Figure 3
) into the power port on the back of
the terminal.
2
Insert the power cable into the power pack.
3
Plug the power pack into a wall outlet or surge protector.
Figure 3
Connect Omni 3600 Terminal Power Pack
Smart Battery
The Omni 3600 wireless terminal uses an Li-ion smart battery (see
Accessories
and Documentation
for ordering information). The internal logic of the smart
battery prevents both overcharging and undercharging (a fault condition in which
the battery level goes well below the minimum acceptable charge and the battery
becomes unusable).
NOTE
Install a power surge protector to protect against possible damage caused by
lightning strikes and electrical surges.
WARNING
Do not plug the power pack into an outdoor outlet.
CAUTION
Note that a new Li-ion battery’s full performance is achieved only after
two or three complete charge and discharge cycles.
On initial use, allow the Omni 3600 smart battery to charge 4 hours,
then fully discharge during normal operation, to ensure reliable battery
operation.