Verismo V?585 Operating Manual - page 9
16
17
EN
EN
The water filter symbol appears only if the
setting "FIlter available" was previously
activated.
Manually enabling
the cleaning,
descaling or filter
change functions
Changing the filter
(when prompted)
continued
°C
°C
°C
Press the Rinse button for at least
3 seconds.
Cleaning symbol blinks. For the
cleaning process, please follow the
operating steps on pages 11–12.
Filter symbol blinks. For filter
replacement, please follow the
operating steps on pages 15–16.
To return to descaling function, press
the Rinse button briefly.
Descaling symbol blinks again
(program loop).
Switch off appliance to exit
program loop.
Descaling symbol blinks. For the
descaling process, please follow the
operating steps on pages 13–14.
°C
For next function, press the Rinse
button briefly.
For next function, press the Rinse
button briefly.
1
2
3
4
5
6
7
8
9
Screw in new water filter.
Place a container under spout.
Refill water tank completely and
reinsert it.
Press the Rinse button.
Remove drip trays with used pod
container.
(Before removing the drip trays, make sure
that the spout is in its uppermost position.)
Appliance is ready for operation.
Empty and clean drip trays. Wipe
connector on lower drip tray with
a dry cloth.
Reinsert drip trays with pod container.
Appliance heats up.
°C
max
3.5 l / 118 fl oz
min
0.25 L /
8.45 fl oz
Wait until rinsing process is finished,
then empty container.
9
10
11
12
13
14
15
16
17
WARNING
WARNING: Make sure the lever is closed
completely during use. Extremely hot water
runs through the appliance when operating
(brewing, descaling, cleaning, rinsing). To
avoid the risk of scalding or other injury,
always keep the lever in the closed / down
position while machine is operating. Do not
reach under the spout and do not remove the
drip tray.
After inserting the filter, check if setting
“Filter existing“ is activated. Refer to
instructions under “Parameter setting: Water
filter“ (see page 18). An already activated
setting remains active.