VERITAS Constellation series Setup Manual - page 4
Getting Started
Connecting your Constellation Access Point
Important
Turn the power switch off before connecting or disconnecting the AC Power Cable
Step 1
Connect one end of a 6-pin LEMO cable to either a Constellation 60 or Constella-
tion 120 LED
Step 2
Connect the other end of the 6-pin LEMO cable to any of the 6-pin LEMO connec-
tors found on the front of the Constellation Access Point
Step 3
If using Sync-in and Sync-out, connect Sync-in and Sync-out SMA cables to their
respective SMA connectors located on the front of the Constellation Access Point
Step 4
Make sure the power switch is in the “OFF” position and connect the included AC
Power Cable first to the Constellation Access Point and then the other end to a
wall
outlet.
Step 5
Turn the power switch to the “ON” position
Controlling your Constellation Access Point without a computer
Your Constellation Access Point can be controlled without the use of a computer. Simply follow
the steps in the “Connecting your Constellation Access Point” section above. You can then place
the Constellation 60 or Constellation 120 LEDs in to continuous mode (Switch set to “ON”),
pulse mode (Switch set to “Pulse”) using a sync signal from an external sync source using the
Constellation Access Point’s onboard “SYNC IN” SMA connector.
8x 6-pin LEMO
Connectors
ON LED Indicator
Pulse LED Indicator
On / Pulse Switch
Sync-in
SMA Connector
Sync-out
SMA Connector
USB 2.0 Connector
STATUS LED
WiFi SMA Connector
GPS SMA Connector
Power Switch
RJ45 Ethernet Connector
FRONT
4