Void Bias Q5 User Manual - page 10
Bias Q5 User Guide V1.0
Page 10
FCC COMPLIANCE NOTICE
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
CAUTION: Changes or modifications not expressly
approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the
equipment and receiver.
•
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
•
Consult the dealer or an experienced
radio/TV technician for help.
WEEE DIRECTIVE
If the time arises to throw away your product,
please recycle all the components possible.
This symbol indicates that when the end-user
wishes to discard this product, it must be sent
to separate collection facilities for recovery and
recycling. By separating this product from other
household-type waste, the volume of waste
sent to incinerators or land-fills will be reduced
and natural resources will thus be conserved.
The Waste Electrical and Electronic Equipment Directive
(WEEE Directive) aims to minimise the impact of electrical
and electronic goods on the environment. Void Acoustiscs
comply with the Directive 2002/96/EC and 2003/108/
EC of the European Parliament on waste electrical
finance the cost of treatment and recovery of electronic
equipment (WEEE) in order to reduce the amount of
WEEE that is being disposed of in land-fill site.
All of our products are marked with the WEEE symbol;
this indicates that this product must NOT be disposed
of with other waste. Instead it is the user’s responsibility
to dispose of their waste electrical and electronic
equipment by handing it over to an approved reprocessor,
or by returning it to Void Acoustics for reprocessing.
For more information about where you can send
your waste equipment for recycling, please contact
Void Acoustics or one of your local distributors.
EC DECLARATION OF CONFORMITY
Manufacturer:
Void Acoustics Research Ltd
Unit 15, Dawkins Road Ind Est.,
Poole,
Dorset, BH15 4JY,
United Kingdom
We declare that under our sole responsibility the products:
Model Names: Bias Q5
Intended use: Professional Audio Amplifier
Are in conformity with the provisions of the following
EC Directives, including all amendments, and with
national legislation implementing these directives:
•
2006/95/EC Low Voltage Directive
•
2004/108/EC Electromagnetic Compatibility Directive
•
2002/95/CE RoHs Directive
The following armonized standards are applied:
•
EN 55103-1
•
EN 61000-3-2
•
EN 61000-3-3
•
EN 55103-2
•
EN 61000-4-2
•
EN 61000-4-3
•
EN 61000-4-4
•
EN 61000-4-5
•
EN 61000-4-6
•
EN 61000-4-11
•
EN 60065
For compliance questions only: info@voidacoustics.com
1 Regulatory information