VOKERA Syntesi e User Instructions - page 7
6
e
INTRODUCTION
The Vokera RC05 remote control is an optional acces-
sory that enables the boiler and its functions to be con-
trolled from another location from that of the boiler. The
RC05 can be used a room thermostat or programmable
room thermostat and can also be connected to an out-
side temperature sensor.
When the RC05 is connected to the boiler the controls on
the boiler are over-ridden by the RC05.
These instructions should be read in conjunction with the
RC05 instructions if your installer has connected an RC05
remote control to your boiler.
QUICK-REFERENCE GUIDE
Boiler switched off – OFF is shown in the display
Hot Water only – press
until the
symbol is
shown in the display. To adjust the hot water outlet tem-
perature, press
then press the + or – buttons until the
required temperature is displayed, press ENTER to store
the new setting.
4.1
WHAT IF I SUSPECT A GAS LEAK
If you suspect a gas leak, turn off the gas supply
at the gas meter, and contact your installer or
local gas supplier. If you require further advice
please contact your nearest Vokera office.
4.2
WHAT IF I HAVE TO FREQUENTLY TOP-UP
THE SYSTEM
If the system regularly requires topping-up, it may
be indicative of a leak. Please contact your in-
staller and ask him to inspect the system.
4.3
WHAT IF THE STATUS LED IS FLASHING RED
If the red LED is flashing it indicates that the boiler
or system has developed a problem, when this
happens the boiler automatically shuts down and
requires to be reset manually (see 3.2).
WHAT IF....
VOKERA RC05 REMOTE CONTROL
4.4
WHAT IF THE APPLIANCE IS DUE ITS ANNUAL
SERVICE
Advice for tenants only
Your landlord should arrange for servicing.
Advice for homeowners
Please contact Vokera Customer Services (0870
333 0220 (UK) or 05655057 (ROI) if you would
prefer a Vokera service engineer or agent to serv-
ice your appliance. Alternatively your local CORGI
registered engineer may be able to service the
appliance for you.
4.5
WHAT IF I NEED TO CALL AN ENGINEER
If you think your boiler may have developed a
fault please contact your installer or Vokera Cus-
tomer Services (0870 333 0220 (UK) or 05677
55057 (ROI) have all your details to hand includ-
ing full address and postcode, relevant contact
numbers, and your completed appliance log
book.
Heating & Hot Water – press
until both the
&
symbols are shown in the display. To adjust the hot
water outlet temperature and/or Heating outlet tempera-
ture, press
until the required symbol is flashing
or
then press the + or – buttons until the required tem-
perature is displayed, press ENTER to store the new set-
ting.
Adjusting the room temperature setting – with the con-
trol set to the Heating & Hot Water mode, press ENTER
the currently set room temperature will begin to flash. Use
the + or – buttons until the required temperature is dis-
played, press ENTER to store the new setting.
FAULT CONDITION- the
symbol and a fault code will
appear in the display. Press RESET to enable the appli-
ance to reset itself. Should an alarm code be repeatedly
displayed, consult the users guide for specific help. Al-
ways allow at least 2-minutes before resetting the ap-
pliance.