Volaris RA User Manual - page 4
4
x2
Seat height adjustment
Remove any profile clips (see page 9). Adjust one
side at a time. Pull out the knob under the seat. At
the same time, raise or lower the seat to the position
required. Release the knob, ensuring that it locates
properly to secure the seat in place. Do the same on
the other side. Check carefully that the seat is level
before using the rollator. Press down the centre sec-
tion of the seat. Place the profile clips in the notches
on the profile, both above and below the seat (see
page 9).
Handle height
The handle is at the correct height when the lower
arm rests comfortably on the armrest's cushion, ap-
prox. 90 degrees between the upper and lower arm.
When you walk using the rollator, you should walk
without bending forwards, keep the rollator close to
your body, keep your back straight and look straight
head.
Adjust the handle height
Slacken off the knob. Adjust the height of the handles
by pulling out the knob and adjusting the height; see
the setting heights on page 16. After this, adjust the
height and then check that the knob "clicks back"
and tighten the knob. Once you have used the RA for
a while, you will feel if you want to make any further
adjustments. You should feel comfortable when walk-
ing with your rollator. Mechanical stop for maximum
handle height. Number of visible holes constitute
marked height interval.
Adjustment