Volfoni VBAE-01000 User Manual - 4. Quick Start
6
7
4. QUICK sTART
To watch active displays using your ActivEyes system
in universal infra-red 3D mode :
1. Using the connection cable, plug the ActivEyes Pro
to the ActivMe Pro, and place the glasses on your
head.
2. Check that the “function” selector on the ActivMe
Pro is on “1”.
3. Switch the power on. The glasses should blink once
each eye to signal that the system is up and running.
4. As soon as the IR or RF signal is identified and
interpreted, the glasses go into 3D mode. You can
now attach the ActivMe Pro to the front of your
clothing or attach to the lanyard, making sure that
the IR window is not obscured.
To watch passive displays (for VBAE-01000 models
only) :
Simply wear your ActivEyes Pro. There’s no need to
plug or power on the ActivMe Pro.
5. CHARGInG BATTERY
To charge the ActivMe Pro, plug it in using the
Micro-USB cable to any 5V USB power source (or
computer). The LED should go red until the battery
is fully charged, then the LED goes green, typically
after 2.5 hours. The battery is estimated to last 30
hours before needing a recharge. Your ActivMe can
operate while charging.
6. UPDATE YOUR ACTIVEYEs PRO
Before using the ActivEyes Pro glasses, make sure
you have the latest version of software from our
website. For this purpose, please download the «
Volfoni Loader » software (http://www.volfoni.com/
en/services-support/download) and connect your
glasses to your computer. Then start the software and
follow the instructions below.
- choose the menu “SUPPORT”
- choose “Upgradable Software”
- download the application “VOLFONI LOADER”
- connect your computer to the μUSB connector on
ActivMe with the USB/μUSB cable
- press and hold the button of the ActivMe, and
switch ON the ActivMe
- the LED of the ActivMewill light red
- verify that the application recognizes your system
- once you are connected, press the button “Check
for updates”
- download the lastest version