Volfoni VPEG-05010 User Manual - 4. Using Your Edge
10
11
4. USING YOUR EDGE
TM
VR
4.1 ON/OFF and Auto OFF
ON :
Turn the glasses ON with just a short press of the ON/OFF
button. When switched ON, the lenses will alternately
flash one time (left and right) to indicate to the user that
the glasses are powered ON.
OFF :
Turning the glasses OFF is possible by holding down the
ON/OFF the button.
The glasses will turn off automatically in the following
cases:
- Loss of IR/RF synchronization after 10 minutes.
- The ActivHub
TM
RF has several modes of operation (12),
selectable with the wheel. Please select position 8 to use
the EDGE
TM
VR properly.
Auto test mode : position 0
Please note that positions 1 and 2 are not meant to be
used in the ActivHub
TM
RF50.
- When the configuration is ready, please stand in front
of the screen and press the On / Off button on your
glasses.
- The glasses will automatically search the
synchronization signal.
Once the glasses are synchronized, the LCD lenses will
flash ultra-fast. Then you can watch your 3D content
The ActivHub
TM
can transmit RF synchronization when
connected to a VESA or BNC cable
The ActivHub
TM
can transmit RF synchronization when
receiving a DLP-Link 3D signal.
3D Content
Movie, sports...
RF glasses
ActivHUB
3D Content
Movie, sports...
RF glasses
ActivHUB
3D Content
Movie, sports...
RF glasses
ActivHUB
The ActivHub
TM
can transmit RF synchronization when
receiving an IR 3D signal.