Vollrath SLR7912/N Operator's Manual - page 4
O
peratOr
’
s
M
anual
4
A
Figure 3. Knife Cover
6. Lift the knife sharpening assembly (A) and rotate it 90°, then lift to remove
it. See Figure 4.
A
Figure 4. Knife Sharpening Assembly
7. Unscrew and remove the product grip handle and clean the product
grip (A). Figure 5.
A
Figure 5. Product Grip Handle
8. Unscrew and remove the carriage tray shaft (A). Figure 6.
A
Figure 6. Carriage Tray Shaft
9. Unscrew the carriage tray release knob (A), tilt the carriage tray (B) and
clean. See Figures 7 and 8.
A
Figure 7. Carriage Tray Release Knob
B
C
Figure 8. Carriage Tray and Silicone Seal
Sanitize all the removable parts and the slicer.
10. Wash hands. In a clean basin or sink, in a solution of clean warm water
and correctly diluted sanitizing solution soak and wash the removable
parts. Remove the parts from the basin or sink and allow them to air dry.
11. Wipe the slicer with correctly diluted sanitizing solution.
12. Press a damp cloth slightly moistened with water and correctly diluted
sanitizing solution on the front side of the knife and move slowly from the
center towards the edge; avoid excess of liquid. Figure 9.
Figure 9. Knife Cleaning