VOLTA V-385 Instruction Manual - page 8
11
12
2.2 Recycling time of the flash using
the VOLTA Inverter
(Using the V-385) Recycling time of the flash
(1) The recycling time does not change if the flash recycles in 1 second and does not exceed 800ws
similarly hereinafter).
The time will increase if the flash recycles in 1 second but exceeds 800W/S. The recycling will
become longer but will not exceed 5 seconds.
(2) If the flash recycles in 2-3 seconds and does not exceed 2400
.
The recycling time will increase if the flash recycles in 2-3 seconds but exceeds 2400W/S. The
time becomes longer but will not exceed 5 seconds.
(3) The time does not change if the flash recycles in 3 seconds and does not exceed 3000W/S.
ill increase if the flash recycles in 3 seconds but exceeds 3000W/S. The
recycling becomes longer but does not exceed 5s.
2.3
Amount of Full-Powered Flashes with a Fully Charged V-385
( ) Approximately for one
s flash.
( ) Approximately 7 for one 7
s flash.
(3) For the values of flashes with other power levels, refer to the preceding values.
3. LED Lamp Alarm
When a flash is first energized by the inverter, the transient current of the flash is no less than 3
times its full-load current. For example, a 100ws flash may have a transient current equal to the
full-load current of a 300ws lamp. Therefore, when the V-385 is used for specific flashes, the
“Power Indicator (06)” will blink with a short beep. This is normal when the transient current of the
flashes exceed 800W.
If the “Power Indicator (06)” blinks and beeps for over 5 seconds, the equipment will automatically
shut down.
Should this happen, turn “
Switch (04)” to power the inverter on for use.
VII. Replacing Fuses
The VOLTA V-385 is equipped with three 30A fuses.
Should the inverter fail to operate properly, check if the fuses are melted. If so, replace with
new fuses.
Ensure that the inverter is turned off before replacing any fuses. Unplug the bad fuses and insert
new ones.
VIII. Product Compatibility
The inverter can be used with a wide range of electrical products such as studio lights and
non-flash electrical appliances. We have yet to find any incompatible products. If you find a
product that does not work with the inverter please contact us at info@studio-assets.com.
IX. Maintenance and Warranty
To avoid performance degradation caused by accumulated dust, wipe the surface of the inverter
with a damp clean cloth. If the inverter has been stored for a long period of time, please charge
before using to obtain the best performance.
Each Volta V-385 Power Inverter goes through a detailed inspection and quality check before
leaving the factory.
A Limited One-Year Warranty is provided for the Volta Power Inverter. The warranty guarantees,
under normal use, that the product will be free from defects in workmanship and in materials for
the period of one year from the purchase date. Any accidental and user damage is not covered
under the warranty. Any signs of tampering, unauthorized service, or modifications will void the
warranty.
Should any issues occur, please email us at info@studio-assets.com or visit our website
www.studio-assets.com.