W Audio SPEA43 User Manual - page 5
Make sure that the area below the installation place is blocked when rigging, derigging or
servicing the system.
Please note:
W Audio cannot be made liable for damages caused by incorrect installations and
excessive noise levels.
Gig Rig Performer Mixer Amplifier Features:
• Four channel mixer amplifier
• Rugged, carpet covered housing complete with steel corner guards and a rubber carry handle
• Balanced XLR microphone inputs
• 1/4” 6.35mm line level inputs
• CD/TAPE input located on rear panel
• Master volume & effects controls
• Speaker output sockets - 6.35mm (1/4”) jack
• Effects loop - enables use of external processing
• Record output - ideal for use with external audio recorders
• 3 band EQ on main output
• 2 band EQ on each input channel
• Convection cooled
• 2 x 75Wrms (2 x 100W peak) power output
• Dimensions: 490 x 270 x138mm
• Weight: 7.3Kgs
Gig Rig Performer Speaker features:
• Continuous (RMS) power: 75W
• Peak power: 100W
• Efficiency (1watt/1metre): 93dB
• Frequency range (-3dB): 60Hz - 18kHz
• Low frequency transducer: 10”/250mm
• High frequency transducer: 3” x 7” Piezo Horn
• Crossover frequency: 4kHz
• Nominal impedance: 4 Ohms
• 6.35mm Jack Socket x 2
• 35mm stand mountable
• Durable black carpet finish
• Dimensions: 360 x 295 x 535mm (L x W x H)
• Weight: 9.7Kgs
Unpacking and transportation:
Unpack the units and examine them for transport damage.
When boxed in the original packaging the speaker system should be carried by two persons of the
same size. Carrying the speaker system with one person alone should be avoided as the heavy
weight and strain could lead to back injury. Please note that all speaker systems weighing more
than 25Kgs must be transported by two persons.
5