W Audio SPEA43 User Manual - page 8

Start Up

Make sure that the power switch is set to “OFF” before you connect the speakers.

Inputs

A good quality cable run improves the sound quality considerably. Input cables should be short 

and direct, since high frequencies may be absorbed if the cables are unnecessarily long. Also a 

longer cable may lead to humming and noise problems. If long cables runs are unavoidable, you 

should use balanced cables.

In order to obtain the highest sound quality, only use high quality cables for connecting the units. 

Balanced XLR Connection

Connection With The Mains

Connect the unit to the mains with the power plug.

The earth has to be connected.

Switch the unit on. After switching on the speaker system, wait 8 - 10 seconds before you turn the 

volume control up in order to avoid speaker damage.

Always check the sound pressure level with a meter in order to keep to the legal threshold.

8