W Audio ZENITH 2K5 Operation Manual - page 6
page 6
Operation Manual
2 Setup
2.1 Unpack Your Amplifier
Please unpack and inspect your amplifier for any
damage that may have occurred during transit. If
damage is found, notify the transportation company
immediately. Save the shipping carton as evidence
of damage for the shipper s inspection.
We also recommend that you save all packing materials
so you will have them if you ever need to transport the
unit. Never ship the unit without the factory packaging.
YOU WILL NEED (not supplied):
Output wiring cables
Input wiring cables
Rack for mounting amplifier (or a stable surface for
stacking)
WARNING: Before you start to set up your
amplifier, make sure you read and observe
the Important Safety Instructions found at
the beginning of this manual.
2.2 Install Your Amplifier
CAUTION: Before you begin, make sure your ampli-
fier is disconnected from the power source, with
the power switch in the off
position and all
level controls turned completely down (counterc-
lockwise).
Use a standard
equipment rack .
See Figure 2.1 for amplifier dimensions.
19-inch (48.3 cm)
You may also stack amps without using a cabinet.
NOTE: When transporting, amplifiers should be
supported at both front and back.
2.3 Ensure Proper Cooling
When using an equipment rack, mount units directly
on top of each other. Close any open spaces in the
rack with blank panels. DO NOT block front, rear or
side air vents. The side walls of the rack should be
a minimum of two inches (5.1 cm) away from the
amplifier sides, and the back of the rack should be
a minimum of four inches (10.2 cm) from the amp-
lifier back panel.
Figure 2.1
Dimensions
483.0 mm
462.0 mm
8
8
.0
m
m
Professional Power Amplifier
dB 0
8
-
dB 0
8
-
I
O
PROTECT
CLIP
SIGNAL
ACTIVE
PROTECT
CLIP
SIGNAL
ACTIVE
POWER
CH A
CH B
ZENITH 2K5