W Audio ZENITH 2K5 Operation Manual - page 7
Operation Manual
page 7
2 Setup
Figure 2.2
Balanced Input
Connector Wiring
Figure 2.3
Unbalanced Input
Connector Wiring
Figure 2.4
Left: Speakon Output Connector on Back Panel
Right: Speakon Cable Connector
OUTPUT ASSIGNMENT
PIN 1+ :
PIN 1- :
SIGNAL
GROUND
PIN 1+ :
PIN 1- :
SIGNAL
GROUND
OUTPUT A
OUTPUT B
2.4 Choose Input Wire and Connectors
recommends using pre-built or professionally
wired, balanced line (two-conductor plus shield), cables
and connectors. Depending upon which amplifier input
you choose, you should use either 3-pin male XLR
connectors, or jack connectors for the amplifier inputs.
Unbalanced line may also be used but may result in
noise over long cable runs.
Note: Amplifier input connectors not used for audio signal
input may be used for the daisy-chaining of the audio
signal to other components.
Figure 2.2 shows connector pin assignments for balanced
wiring, and Figure 2.3 shows connector pin assignments
for unbalanced wiring.
NOTE: Custom wiring should only be
performed by qualified personnel.
2.5 Choose Output Wire and Connectors
recommends using pre-built or professionally
wired, high quality, two or four-conductor, heavy gauge
speaker wire and connectors. You may use two 4-pole
Speakon connectors (Figure 2.4 and Table 1) or banana
plugs, To prevent the possibility of short-circuits,
wrap or otherwise insulate exposed loud speaker cable
connectors.
Professional Power Amplifier
BRIDGE
Use both red Binding Posts
CAUTION: Never use shielded cable for output wiring.