W Audio ZENITH 3000 Operation Manual - page 6
page 6
Operation Manual
2 Setup
2.1 Unpack Your Amplifier
Please unpack and inspect your amplifier for any damage
that may have occurred during transit. If damage is found,
notify the transportation company immediately. Save the
shipping carton as evidence of damage for the shipper s
inspection.
We also recommend that you save all packing materials so
you will have them if you ever need to transport the unit.
Never ship the unit without the factory packaging.
YOU WILL NEED (not supplied):
Output wiring cables
Input wiring cables
Rack for mounting amplifier (or a stable surface for
stacking)
WARNING: Before you start to set up your
amplifier, make sure you read and observe
the Important Safety Instructions found at
the beginning of this manual.
2.2 Install Your Amplifier
CAUTION: Before you begin, make sure your ampli-
fier is disconnected from the power source, with
the power switch in the off position and all
level controls turned completely down (counterc-
lockwise).
Use a standard
equipment rack .
See Figure 2.1 for amplifier dimensions.
19-inch (48.3 cm)
You may also stack amps without using a cabinet.
NOTE: When transporting, amplifiers should be supported
at both front and back.
2.3 Ensure Proper Cooling
When using an equipment rack, mount units directly on top
of each other. Close any open spaces in the rack with blank pa-
nels. DO NOT block front, rear or side air vents. The side w-
alls of the rack should be a minimum of two inches (5.1 cm)
away from the amplifier sides, and the back of the rack sh-
ould be a minimum of four inches (10.2 cm) from the amp-
lifier back panel.
Figure 2.1
Dimensions
483.0 mm
462.0 mm
8
8
.0
m
m
Professional Power Amplifier
dB 0
8
-
dB 0
8
-
I
O
PROTECT
CLIP
SIGNAL
ACTIVE
PROTECT
CLIP
SIGNAL
ACTIVE
POWER
CH A
CH B
ZENITH 3000