W & H 154 Operator's Manual - Safety Rules
SPECIFICATIONS
ACCESSORIES
MOTOR
2HP
GUIDE SYSTEM
GS-2
RPM
6900
ELLIPTICAL JIG
EJ-92
FEED RATE
15 FPM
RETRO KIT
VF-104-K
MAX PROFILE DEPTH
¾”
RETRO KIT
VF-106-K
MAX PROFILE WIDTH
6 ¾”
11FPM KIT
54-310-K
PLANING WIDTH
7”
20FPM KIT
54-311-K
MIN STOCK LENGTH
9”
R. PANEL KIT
54-312-K
MIN STOCK THICKNESS
¼”
CRANK EXTEND
54-306
MAX STOCK THICKNESS
8”
PINT OF G. B. OIL 54-416
WORKING HEIGHT
35”
OVERALL HEIGHT
50”
OVERALL WIDTH
22”
OVERALL LENGTH
28”
SHIPPING WEIGHT
218#
SAFETY RULES
Your 154 Molder has been designed for maximum safety. However, as with all power tools, there is a
possibility of incident or injury to the operator. Therefore, it is imperative that this manual is completely read
and understood before using.
Use your 154 Molder with respect and caution. Following stated and inherent safety precautions will
considerably lessen the possibility of personal injury. If normal safety measures are not taken or are overlooked,
the possibility of incident rises tremendously. These safety measures are simple to follow, and the injuries that
could happen are not worth the few minutes saved by ignoring safety.
The 154 Molder was designed for specific applications. Do not modify or use the machine for any purpose other
than what this manual describes as its capabilities. Substituting a motor with a horsepower rating over 2HP
constitutes a modification. Any modifications or improper use to the Molder-Planer may result in personal
injury, and will void the warranty. Please contact us if you are unsure about safety protocol before using the
machine.
SAFETY CHECK LIST
DON’T TAKE UNNECESSARY RISKS!
Failure to read and apply the manual instructions will cause poor performance, unnecessary repairs and
injury.
Wear safety glasses and respiratory protection.
2