W3 Gear NinjA Micro Owner's Manual - Structure Layout
Structure Layout
Lens: The business-end of the camera, used to focus light on to the image sensor. For best result, ensure the
lens is clean and free from debris.
Mode Select: Changes the recording mode of the camera.
Micro SD Card Slot: The slot for inserting the Micro SD card which the NinjA Micro™ camcorder records to.
To insert a card, simply push it into the slot. To remove it, push it in again, and it will “pop” right out.
Reset Button: Used to quickly return the NinjA Micro™ camcorder to its initial booted state. This is typically
used only if the NinjA Micro™ camcorder freezes and needs to be reset.
Strap Clip: Used to attach the included neck strap. Alternatively, it can be used to attach the NinjA Micro™
camcorder to just about anything – such as a key-chain or similar.
Power: Press to turn the NinjA Micro™ camcorder on and off. Do not turn off the NinjA Micro™ camcorder
while recording, or immediately after recording.
Record/Stop: Starts and stops the NinjA Micro™ camcorder recordings.
Microphone: The device which records sound. If these holes are blocked, then the range and quality of the
audio recording will be significantly reduced.
LEDs: Small colored lights which will indicate the current state and function of the NinjA Micro™ camcorder.
There are two LEDs, one red and one blue. In bright light (such as sunlight) these might be difficult to see.