W3 Gear NinjA Micro Owner's Manual - page 5
great solution for a set-and-forget recording device. The internal battery will last for more than 10 hours of
standby time if nothing triggers the NinjA Micro™ camcorder to record.
Soft sounds (for example, softer than a person speaking in a loud voice approximately 3ft/1m away) may not
trigger the NinjA Micro™ camcorder to record.
To engage Sound-Activated Recording Mode:
•
Turn the NinjA Micro™ camcorder on in the usual way.
•
Wait until the red LED goes out, and the NinjA Micro™ camcorder is in standby.
•
Press the Mode button.
•
The blue LED will stay on, and the red LED will flash slowly to indicate that the NinjA Micro™ camcorder is
in sound-activated recording mode.
•
While armed in this mode, a moderate to loud sound will trigger the NinjA Micro™ camcorder to record.
•
Once triggered to record, the NinjA Micro™ camcorder will continue recording for a minimum of two
minutes, or longer if the sound continues.
•
To deactivate the sound-activated recording mode, simply press the mode button. Once the red LED goes
out, sound-activated recording mode has been deactivated.
Mounting the NinjA Micro™ camcorder
Neck Strap
Using the Neck Strap is pretty straight forward, and a great way to make sure you never lose the NinjA
Micro™ camcorder – it’ll be round your neck!
•
Attach the clip on the end of the strap to the small tab on the top of the NinjA Micro™ camcorder
•
Sling the strap around your neck
•
For best results, hold the NinjA Micro™ camcorder steady whilst you’re shooting video – leaving it on the
neck strap will result in a very random, frenetic video which will rarely capture what you want.
Belts/Pockets Clip (or Silicone Case)
•
Inset the NinjA Micro™ camcorder into the bracket.
•
The four corners of the clasp will lock into position on the four corners of the NinjA Micro™ camcorder
•
The NinjA Micro™ camcorder can now be clipped onto a belt, pocket, collar, or any other location which
offers suitable support for the clip.
•
To remove the NinjA Micro™ camcorder from the clip, hold it in the middle and twist gently. The clip is
easiest to remove one corner at a time.
•
The silicon sleeve works in a similar manner, and has a loop on the back to attached to a belt or similar.
The differences are primarily that a) the silicon sleeve is more delicate, and could tear if mistreated and b)
the silicon sleeve will offer some degree of protection from scratches, dust and moisture.
Wall /Ceiling Mounting Options
The NinjA Micro™ camcorder comes with two options for permanent mounting, a permanent clip and a clip-to-
wall mounting. If you want to use the NinjA Micro™ camcorder with the belt/pocket clop, use the free-pivot
Wall Bracket mounting that the clip can attach to. To mount the NinjA Micro™ camcorder only, use the
standard wall clip.